A grommet is a ring or edge strip inserted into a hole through thin material, typically a sheet of textile fabric, sheet metal or composite of carbon fiber, wood or honeycomb. Continue reading
Urethane Restoration Team: Summary
January 26, 2018Part Seven
Urethane Restoration Team: Flatness Matters
November 13, 2017Part Four
Urethane Restoration Team: Temperature Variation Matters
October 23, 2017Part Three
Urethane Restoration Team: The Strategy
October 9, 2017Part Two
Urethane Restoration Team: The Problem
September 26, 2017Part One
Molded Dimensions Team Earns Best Technical Paper
September 18, 20172017 Best Technical Paper
by Linda Katz, Molded Dimensions, Inc., PMA President Continue reading
Linda Katz in Rubber & Plastics News
August 17, 2017Our owner, Linda Katz, was recently featured on Rubber & Plastics News discussing the growth opportunities for polyurethanes. Here’s what she said: Continue reading
Polyurethanes are Saving Lives
June 27, 2017Polyurethanes are used in numerous ways in the medical world, and allow for the creation of many medical devices Continue reading
Rubber To Metal Adhesion
July 29, 2016The processes of adhering rubber Silicone Parts – Molded Dimensionsto metal components are widespread techniques in the rubber industry. Generally the same considerations and procedures are applicable for rubber to rigid non-metallic components, but the adhesion values may be lower. Various adhesion levels can be obtained. For instance, to obtain adhesion on critical products, such as engine mounts, very close controls are required, both on metal and rubber preparation. Some products may require only enough adhesion for assembly. The adhesion level (tear/tensile strength) is directly affected by type of metal, surface preparation, non-metallic inserts, compound composition, curing conditions, and type of adhesive. Continue reading